Authorized Hit-Air Dealer
Personal Airbag Vests


Browse by category:


Hit-Air Red Slide for B Keybox

Code: RedSlide
Price: $10.00
Shipping Weight: 0.10 pounds
Quantity in Basket: None

Red slide replacement cover for B Type Keybox. This cover can optionally be used in the down position (locked) to insure the Keyball is flush when resetting the Keyball after a deployment. Make certain the red slide is in the up position (unlocked) after resetting the keyball, then installing a new cartridge and before wearing the vest. I recommend that you put the red slide in the up position immediately after resetting the keyball so that the vest is ready to use and you don't forget this critical step.

How To Replace Red slide on Key box

Step 1) Remove CO2 canister, then remove key ball using the hex wrench to turn

the bolt slightly to ease the pressure of the spring to make it easier to remove the

key ball. See Figure with canister installed

Step 2) Remove the two screws on the upper and lower brackets that secures the key box (See Figure 1.)

Step 3) Pull the key box out of the vest. Keep this area free of dirt and debris and

keep the black O ring clean. Figure 2 is the key box removed

See Figure 2

Step 4) Carefully unscrew the black bottom cap that contains the spring, Do not

remove spring. Now you can remove the broken red slide. note the grove on the

red slide to know how to replace the new slide on the notch on the key box.

See figure 3

Step 5) Slide the red slide off taking note of the notch on the key box and the

groove on the slide so that you can align them when you install the new slide.

Install the new red slide.

See figure 4

Step 6) Screw the cap back on the bottom of the key box and insert the key box

back into the vest.

Step 7) Reinstall the upper and lower brackets to secure the key box to the vest

Step 8) Reinstall the key ball into the key box

Step 9) Slide red slide to the up position

Step 10) Install new canister.